Connecting A Satellite Receiver (Sat) And A Vcr - Sony 53S75 Operating Instructions Manual

Installing and Connecting the Projection TV (continued)
Connecting a satellite receiver
(SAT) and a VCR
1
Connect the cable from the satellite
antenna to the satellite receiver.
2
Attach the coaxial cable from the
incoming cable connection or antenna to
VHF/UHF IN on the VCR.
3
Using a coaxial cable, connect VHF/UHF
OUT on the VCR to VHF/UHF on the
projection TV.
4
Using AUDIO and S VIDEO* cables,
connect AUDIO and S VIDEO OUT on the
satellite receiver to AUDIO and S VIDEO
IN on the VCR.
5
Using AUDIO and S VIDEO* cables,
connect AUDIO and S VIDEO OUT on the
VCR to AUDIO and S VIDEO IN on the
projection TV (White-AUDIO Left, Red-
AUDIO Right).
*
If your VCR is not equipped with S VIDEO, use a
VIDEO cable (yellow) instead of the S VIDEO
cable.
Note:
• To view input from the satellite receiver or
VCR, select the video input which your
satellite receiver or VCR is connected to
by pressing TV/VIDEO on the remote
control.
12
Disconnect all power sources before making any connections.
(Rear of projection TV)
IN
VIDEO 1 VIDEO 3
S VIDEO MONITOR AUDIO
VIDEO Y
L
P
B
(MONO)
AUDIO
P
R R
COMPONENT
VIDEO
S VIDEO
AUDIO-L
AUDIO-R
5
VMC-810S/820S (not supplied)
YC-15V/30V (not supplied)
3
AUX
TO
CONVERTER
VHF/UHF
OUT
1
(VAR/FIX)
VIDEO
Satellite
L
(MONO)
antenna
AUDIO
R
cable
VMC-810S/
820S (not
supplied)
VCR
Coaxial cable
SAT
SATELLITE IN
VHF/UHF
AUDIO R AUDIO L VIDEO S VIDEO
OUT
LINE
OUT IN
YC-15V/
30V
4
(not
supplied)
S VIDEO
AUDIO R AUDIO L VIDEO
LINE
IN
VHF/UHF
OUT
LINE
OUT IN
2
Cable/
Antenna