Connecting With A Vcr, 15K Rgb/Component Equipment - Sony VPL-X1000U Operating Instructions Manual

Connecting

Connecting with a VCR, 15k RGB/Component Equipment

Active speakers
15k RGB/component
equipment
Notes
• Select the RGB or component signal with INPUT-A or INPUT-B in the SET SETTING menu.
• Use the composite sync signal when you input the external sync signal from 15k RGB/component equipment.
• When connecting to INPUT B, make sure that the RGB IN/OUT select switch is set to IN.
20
(EN)
This section describes how to connect the projector with a VCR, external
active speakers and 15k RGB/component equipment.
For details on how to connect a computer, see page 18 (EN).
Also refer to the instruction manuals of equipment to be connected.
When making connections, be sure to:
• turn off all equipment before making any connections.
• use the proper cables for each connection.
• insert the plugs of the cables properly; plugs that are not fully inserted
often generate noise. When pulling out a cable, be sure to pull it out from
the plug, not the cable itself.
VCR
to S video
output
S-Video cable
(not supplied)
VIDEO IN
S VIDEO
AUDIO OUT
INPUT A
MOUSE
AUDIO OUT
Stereo audio
connecting cable
(not supplied)
to RGB/component output
to audio/video
outputs
Audio/video cable
(VPL-X1000U/M: supplied
VPL-X1000E: supplied with the IFB-X600E Interface Board)
AUDIO IN
Rear
(MONO)
VIDEO L R
CONTROL S IN
PLUG IN POWER
IN
OUT
INPUT B
AUDIO MOUSE AUDIO
IN/OUT Note on the VPL-X1000E model
The optional IFB-X600E Interface Board is required for
the VIDEO IN and AUDIO IN jacks.
VIDEO IN AUDIO IN
(MONO)
S VIDEO VIDEO L R
CONTROL S IN
PLUG IN POWER
IN
OUT
INPUT A INPUT B
MOUSE AUDIO MOUSE AUDIO
IN/OUT
SMF-402 Signal Cable (not supplied)
3X phono jack ˜ HD D-sub 15-pin (male)
or
SMF-400 Video Signal Cable (not supplied)
5X BNC ˜ HD D-sub 15-pin (male)
Set this switch to IN.
Rear
Set this switch to IN.