Lincoln Electric FLEX FEED 74 HT Operator's Manual page 33

FLEX FEED™ 74 HT
3. Place the spool on the spindle, aligning the spindle
brake pin with one of the holes in the back side of the
spool. An indicator mark on the end of the spindle
shows the orientation of the brake holding pin. Be
certain the wire feeds off of the spool in the proper
direction.
4. Re-install the retaining collar, with the metal bar
engaging one of the grooves of the spindle. The
release bar will spring out when engaged.
FIGURE A.43
INDICATOR
MARK
A-26
ALIGN BRAKE
PIN WITH HOLE
INSTALLATION