Before You Clean; Carpet Cleaning - Bissell 9200 SERIES User Manual

B
efore You Clean
1.
Plan activities to give your carpet time to dry.
2.
Move furniture to another area if cleaning an
entire room (optional).
3.
Vacuum area with a dry vacuum cleaner
thoroughly before deep cleaning.
4.
Plan your cleaning route to leave an exit path. It is best
to begin cleaning in the corner farthest from your exit.
C
arpet Cleaning
1.
Fill the 2-in-1 water tank. Remove the tank from
the base of the machine by lifting up the tank
carry handle. Carry like a bucket to the sink.
1a.
Unlatch the top of the tank from the bottom by
lifting up on the tank latch which is located on the
back of the tank.
1b.
Remove the top of the tank by lifting up on the handle.
Note how the lip on the top tank separates
from the groove in the bottom tank. This
placement is important when putting the
tank back together.
1c.
Fill the heavy duty bladder with clean hand hot
tap water.
*Do not boil or microwave water as it can
destroy the bladder.
1d
. Leaving the filled bottom of the tank on a flat
surface, only maneuver the top of the tank. To
attach the top part of the tank to the bottom,
carefully hook the lip on the top tank into the
groove on the bottom tank.
1e.
Fasten tanks together by securing the latch in
the back.
Note: Remember to secure the tank latch in
the back and test to make sure it is secure
before picking up the tank.
w w w . b i s s e l l . c o m
ug310-5880_9200E_406.indd 9 ug310-5880_9200E_406.indd 9
ATTENTION:
Some Berber carpets have a
tendency to fuzz with wear.
Repeated strokes in the same
area with an ordinary vacuum
or deep cleaner may aggravate
this condition. Please see Stain
Removal instructions on page 15.
1 1a
1b 1c
1d
1e
Lip
Groove
(underside of
bottom tank)
9
6/9/06 4:25:39 PM 6/9/06 4:25:39 PM