Table of Contents
Advertisement
Problem
Engine does not start
Engine does not run
constantly at no load
Engine does not idle 1.Improper carburetor adjustment.
Engine does not
accelerate
Engine has no power
or stops during
cutting
If further assistance is required, please contact your authorized service dealer.
TROUBLE-SHOOTING
Cause
1. Spark plug wire disconnected.
2. Ignition switch set to OFF.
3. Fuel tank empty.
4. Stale or improperly mixed fuel
mixture.
5. Dirty air filter/oil filter.
6. Incorrectly gapped or dirty spark
plug.
7. Primer bulb not depressed
adequately.
8. Flooded engine.
1. Dirty air/oil filter.
2. Stale or improperly mixed fuel
mixture.
3. Incorrectly gapped or dirty spark
plug.
1. Dirty air/oil filter.
2. Throttle wire disconnected.
3. Defective throttle control lever.
4. Incorrectly gapped or dirty spark
plug.
5. Improper carburetor adjustment.
1. Spool head or blade entangled
with grass.
2. Dirty air/oil filter.
3. Stale or improperly mixed fuel
mixture.
4. Improper carburetor adjustment.
1. Reconnect wire.
2. Set switch to ON.
3. Add fuel.
4. Empty the tank and fill with fresh fuel
mixture.
5. Clean or replace filter.
6. Clean or adjust the gap.
7. Slowly and fully depress the primer
bulb 10 times.
8. Squeeze the throttle and pull the
starter rope with the choke lever in
the operating position.
1. Clean or replace filter.
2. Empty the tank and fill with fresh fuel
mixture.
3. Clean or adjust the gap.
1.Adjust according to the manual or
turn to an authorized service dealer
for help.
1. Clean or replace filter.
2. Reconnect throttle wire.
3. Replace the throttle control lever.
4. Clean or adjust the gap.
5. Adjust according to the manual or
turn to an authorized service dealer
for help.
1. Stop the engine and clean the cutting
attachment.
2. Clean or replace the filter.
3. Empty the tank and fill with fresh fuel
mixture.
4. Adjust according to the manual or
turn to an authorized service dealer
for help.
-14-
Remedy
Advertisement
Table of Contents
