Charging The Battery - Bissell EASYSWEEP 15D1 SERIES User Manual

Assembly

Charging the Battery

1. When completely charged, the EasySweep
provides up to 45 minutes of cleaning time.
2. When charging for the first time, allow to
charge uninterrupted for at least 16 hours.
Thereafter, charge at least 16 hours to fully
renew the EasySweep™ battery. The charging
indicator light will illuminate when properly
connected and will not turn off when fully
charged.
Note: The Power Switch must be in the OFF
position when charging.
3. Decreased operating time may indicate the
battery has built up a resistance. To recharge,
first completely exhaust the battery,
recharge it, and then exhaust it again before
recharging a second time. This procedure
may be required more than once.
4. When charging is complete, be sure to unplug
the EasySweep from the charger.
Operations
Using your EasySweep
The EasySweep is a quick and easy way to
clean your bare floors, low pile rugs and
carpet.
1. Tip back the handle into typical use
position and gently tap the Power Switch
on the sweeper with your foot.
Note: The unit will continue to run even if
the Dirt Bin door is not closed.
2. The handle swivels for easy maneuvering
to clean your bare floors, low pile rugs and
carpet.
3. When done, turn OFF the unit by gently
tapping the Power Switch with your foot
and store for the next use.
ATTENTION
If your battery still fails to recharge
or does not hold a charge of normal
duration, call:
BISSELL Consumer Services
1-800-237-7691
Monday – Friday 8 a.m. – 10 p.m. ET
Saturday 9 a.m. – 8 p.m. ET
Or visit our website at:
www.bissell.com.au
WARNING
EasySweep will not pick up crayons, marbles, and
other large or hard objects.
www.BISSELL.com.au
5