Programing The Remote - Sony BRAVIA 2-691-651-13(2) Operating Instructions Manual

To connect Do this
Digital receiver or Connect to the HDMI IN 1 or 2
DVD player D
jack if the equipment has an
HDMI jack. The digital video and
audio signals are input from the
equipment. If the equipment has a
DVI jack, connect the DVI jack to
the HDMI IN 2 jack through a DVI
- HDMI adaptor interface (not
supplied), and connect the
equipment's audio out jacks to the
audio in the HDMI IN 2 jacks.
Notes
• The HDMI jacks only support the
following video inputs: 480i,
480p, 576i, 576p, 720p, 1080i and
1080p. To connect a PC, use the
PC IN jacks.
• Be sure to use only an HDMI cable
that bears the HDMI logo.
Video game Connect to the S video jack
equipment, DVD or the video jack
player or VCR the audio jacks
EI
avoid picture noise, do not connect
the camcorder to the video jack
1 and the S video jack
at the same time. If you connect
mono equipment, connect to the L
(MONO) jack
DVD player with Connect to the component jacks
component output and the audio jacks
F
2.
Hi-Fi audio Connect to the audio output jacks
equipment G
to listen to the sound from the
TV on Hi-Fi audio equipment.
To turn off the sound of the TV
speakers, set "Speaker" to "Off"
(page 29).
DVD recorder or Connect to the video output jacks
VCR H
to record the image from the
TV. Connect to the audio output
jacks
the TV on the DVD recorder or
VCR.
PC J
Connect to the PC IN jacks. It is
recommended to use a PC cable
with ferrites.
1
1 or 3, and
1 or 3. To
1
1 or 3.
/ 1 or
to record the sound from

Programing the remote

If you have Sony VCRs/DVDs and Sony DVD Home
Theater Systems/Amplifiers, do the following
procedure to program the remote so that you can
operate them using this remote.
Note
Before you start, look up the three-digit code for your
equipment from the "Equipment's codes" on page 38.
1
Press and hold the DVD, VCR or AMP
function button you want to program on the
remote, then press
function button pressed down.
The selected function button (DVD, VCR or
AMP) will flash.
2
Press the number buttons to enter the
three-digit code while the button is lit. If
code is not entered within 10 seconds, you
must perform the step 1 again.
3
Press .
When the programing is correct, the selected
function button will flash twice, and when not, it
will flash five times.
1
2
1
3
, keeping the
Continued
37
GB