Sony UP-970AD Instructions For Use Manual page 10

2
Press the OPEN/CLOSE button to open the paper
door.
3
Place the printing paper roll on the tray.
Using UPP-210SE/210HD
Place the paper with the heat sensitive side facing
up. The printer will not print if the paper is
reversed.
Using UPT-210BL thermal film
*
Cannot be used with the UP-970AD. Doing so may
cause a malfunction.
Correctly Inserted
Incorrectly Inserted
Place the paper with the heat sensitive side facing
up. The printer will not print if the paper is
reversed.
10
Loading Paper in the Unit
Remove label and pull
out 15 to 20 cm (about
6 to 8 inches).
Remove label and pull
out 15 to 20 cm (about
6 to 8 inches).
4
Insert the paper into the groove of the paper tray
and pull it out through the paper exit.
Note
Place the paper near the center of the groove of the
paper tray (inside of the guide). Note that paper
jams may occur if the paper is placed at the edge of
the groove of the paper tray.
Note
Pull out the printing paper to remove any slack and
possible creases.
5
Press the OPEN/CLOSE button to close the paper
door.
You can also push the paper door to close it.
6
Remove paper leading edge.
UP-990AD
After loading paper, press the FEED button to feed
out 15 to 20 cm (6 to 8 inches) of paper and press
the CUT button to remove it.
CUT Button
FEED Button
15 to 20 cm