Compatible With International Standards - Panasonic MGSDB2 Instruction Manual

7. Compatible with international standards

EC directives
EC directives cover all general consumer electronics having specific
functions and to be directly delivered to European Union (EU).
These electronic products must meet safety standards commonly ap-
plicable to all EU member nations, and must bear CE marking.
Our speed controllers are compatible with standards referenced by
Low Voltage Directive so that the machines and devices incorporating
these controllers will meet requirements of EC directives.
Conformance to EMC directives
Our speed controllers have been verified to conform to standards as-
sociated with EMC directives by testing them using application mod-
els (conditions) representing typical installations and wiring with which
these controllers will be used. Of course, it is impossible to simulate
all actual operating conditions (e.g. wiring and grounding). Therefore,
any equipment incorporating our speed controller should be checked
on the items required by EMC directives (especially, unwanted radia-
tion, noise, terminal voltage, etc.).
Pursuant to at the directive 2004/108/EC,article 9(2)
Panasonic Testing Centre
Panasonic Service Europe,
a division of Panasonic Marketing Europe GmbH
Winsbergring 15,22525 Hamburg,F.R.Germany
– 38 –
UL/CE Certification
Standard
UL508
Standard for industrial control devices
UL
such as motor control
EN50178
Electronic/electrical devices used in
electric power facilities (Low Voltage
Directive)
EN55011
Radio interference wave characteristics
of high-frequency devices for industrial,
scientific and medical application
EN61000-6-2
Immunity standard for industrial
environment
(EMC directive)
IEC61000-4-2
Electrostatic discharge immunity test
IEC61000-4-3
CE
Radio frequency radiation field
immunity test
IEC61000-4-4
Electrical high speed transient burst
immunity test
IEC61000-4-5
Lightning surge immunity test
IEC61000-4-6
High-frequency conductivity immunity test
IEC61000-4-11
Instantaneous power interruption immunity test
Installation
File No.
condition
E228869
Overvoltage
Category II
Class II device
Pollution degree 2
– 39 –
–