HP AlphaServer ES47 Cli Reference Manual page 33

PBM
IOR
DUO
CMM
VRMn.CPU
VRMn.RIMM
VRM0.TERM
RIMMnc
PSn
PWRn
PWRn.PSp
CLM
DUO, CMM, VRM and RIMM require the additional
qualifier "-duo" to indicate the residency.
part_num FRU's part number. This field contains the FRU revision.
(This is a 16-character ASCII string with no embedded
spaces.)
serial_num FRU's serial number. This ASCII string must be 10
characters.
model The FRU's model name or number or alias. This ASCII
string may be up to 10 characters. This field is optional and
does not apply to third-party FRUs.
offset The beginning byte offset inhex within this FRU's
EEPROM, where the following data bytes are written.
byte... Up to 16 data bytes to be written. At least one byte must
be supplied after the offset.
Options
-cabinet <cabinet>
-drawer <drawer>
-duo <duo>
-s
-rimm
PBM module
PCI IO riser
DUO module
CMM module
VRM (n = 0-5) for CPUs
VRM (n = 0-4) for RIMMs
VRM for terminator
RIMMs (n = 0-9 for slot
number, c = 0-1 for CPU
processor number)
PCI power supply (n = 0-1)
Power supply tray (n = 0-1)
of SBB
Power supply of SBB
Common Logic Module (of
Superdome PS subsysem)
Cabinet number in hex. If not specified, defaults to 0.
Drawer number in hex. If not specified, defaults to 0.
Dual-CPU module number in decimal.
Write raw data to the EEPROM. Used to apply any
FRU-specific data. Checksum is automatically
updated after the raw data is written.
Build a unique serial number across all RIMMs. The
RIMM number is based on the 12-character system
serial number concatenated with a 4-digit sequence
number determined by the RIMM's location. These
four digits, CDSI, are defined as:
C - Cabinet number 0 - 7
D - Duo number 0 - F (ASCII hex). It is calculated by
(drawer_num * 4 + duo_num)
S - RIMM slot 0 - 9 for CPU0, RIMM0-9; and A - J for
CPU1, RIMM0-9>
I - Insertion count (ASCII 0-9, then A-Z)
Commands
3-9