CPM-QE/ RCM
3.1.4 Diagnosis
The Maincontroller of the HERMES is realised by a Renesas SH726B with 216MHz, 2MB Flash and
1,25MB RAM. In the following blockdiagram you can see the diagnosis ports from ant to the SH2
system controller.
3.1.4.1 Hermes
3.1.5 Operating States
The following picture shows the possible HERMES operating states – these are:
Full Sleep mode, Normal Power mode and DNO mode
3.1.6 HW-clocking table
Device
NAD (Application Processor)
SH2 (CAN Controller)
RL78 (WakeUp Controller)
© HARMAN BECKER AUTOMOTIVE SYSTEMS GMBH
CONFIDENTIAL / ALL RIGHTS RESERVED
Manual Hermes
Clock
666MHz
216MHz
32MHz
2018-05-30 16:03:00
Regulatory Compliance Management
page 10 of 18