Setup The Ups - Delta Amplon MX Series User Manual

2.4 Setup the UPS

Step 1: UPS input connection
Plug the UPS into a two-pole, three-wire, grounded receptacle only. Avoid using
extension cords.
The power cord is attached to the UPS. For the type of power cord, please refer
z
z
to the table below.
Step 2: UPS output connection
There two kinds of outputs: programmable outlets and general outlets. Please
connect non-critical devices to the programmable outlets and critical devices to the
general outlets. During power failure, you may extend the backup time to critical
devices by setting shorter backup time for non-critical devices.
Step 3: Communication connection
USB port
RS-232 port
UPS
1.1kVA
2kVA
3kVA
Chapter 2
Type of Power Cord
Plug 10A Schuko or AU
Plug 16A Schuko or AU
Plug 16A Schuko or AU
1 0
Installation and Setup
Mini slot