Installing Rpms And Line Cards - Dell Networking C9010 Getting Started Manual

Hide thumbs Also See for Networking C9010:

Table of Contents

Figure 18. Installing a Fan Tray

NOTE: The system does not have an air filter; ensure that you regularly clean the installation site and

the chassis.

NOTE: The fan tray light-emitting diode (LED) remains lit when the chassis is powered up and the

fan tray is functioning properly.

Installing RPMs and Line Cards

The C9010 chassis supports up to ten line cards and two route processor modules.

WARNING: Always wear an ESD-preventive wrist or foot-heel ground strap when handling an

RPM or a line card. Always place RPMs and line cards on an antistatic surface or in an antistatic

bag when not in use or when carrying them. ESD damage can occur when components are

mishandled. Do not use the ejector handle to carry an RPM or line card.

CAUTION: Unlock the levers before inserting an RPM or line card into the chassis. After you insert

the RPM or linecard, fully engage the locking mechanism; without the locking mechanism

engaged, you can damage the lower linecard when you insert it.

Installing the Hardware

Table of Contents