Installing RPMs and Line Cards
The C-Series System accommodates eight line cards and two RPMs.
Route Processor Modules
The C-Series system requires the installation of at least one Route Processor Module (RPM); two are
recommended.
• One RPM provides 48 Gigabits of bandwidth to each line card.
• Two RPMs provides 96 Gigabits of bandwidth to each line card.
RPMs are designed to be installed in either the R0 or R1 slot (see
line cards slots. RPMs are keyed differently than line cards to prevent improper installation.
NOTE: If your system contains two RPMs, both RPMs must contain the same software image.
RPM Label and LEDs
Table 5-1
describes the RPM LED states and the RPM front panel.
Table 5-1. RPM Front Panel and LED Descriptions
Section
Label
Management
Console Port
10/100/1000
Ethernet
Alarm LED
Description
Use this RJ-45 jack for the initial system boot, as well as system configuration and
monitoring. Modem connection is not supported on the Console.
Use this non-routable Ethernet port to download images and manage the system. FTP and
Telnet operations are supported. This port is an RJ-45.
Port LEDs:
L/A:
Blinking Amber: 100M speed
Solid Amber: 1G speed
Off: 10M speed
Speed:
Blinking Green: Link detected/ Activity
Solid Green: Link detected/ No Activity
Off: No Link/ Card Offline
Red: Major Alarm—a critical condition exists (such as a severe over temperature condition).
See
Alarms
for more information.
Flashing red: Minor Alarm—a serious condition exists (such as a single fan failure or a line
card failure). See
Alarms
for more information.
Unlit: no alarm conditions.
Figure
2-1). Do not force RPMs into
Installing RPMs and Line Cards
5
|
19