Administering Snmp Trap Reporting; Displaying Trap Information - 3Com SUPERSTACK 2200 User Manual

3-16 C 3: C
HAPTER ONFIGURING
Community string
length
Top-Level Menu
system
ethernet
display
fddi
community
bridge
trap
ip
snmp
analyzer
script
logout
Administering
SNMP Trap
Reporting
Top-Level Menu
system
ethernet
display
fddi
community
display
bridge
trap
addModify
ip
remove
snmp
flush
analyzer
smtProxyTraps
script
logout
M A
ANAGEMENT CCESS TO THE
in the request matches the agent's read-write community. Only the SNMP
get and get-next requests are valid if the community string in the request
matches the read-only community.
When you set a community string, you can specify any value up to 48
characters long.
To set a community string:
1 From the top level of the Administration Console, enter:
snmp community
You are prompted for a read-only community value and then a read-write
community value. If you do not want to change the value of a community
string, press [Return] at either prompt.
2 At the read-only prompt, enter the community string.
3 At the read-write prompt, enter the community string.
For network management applications, you can use the Administration
Console to manually administer the trap reporting address information.

Displaying Trap Information

Displaying the trap reporting information shows you the various SNMP traps
and the current configured destinations, as well as whether the proxying of
remote SMT traps is enabled or disabled.
To show the configured trap reporting information, enter the following from
the top level of the Administration Console:
snmp trap display
S
YSTEM