Care And Cleaning; Important Note - Salton JK1250 Instruction Booklet

Cordless electric jug kettle

DO NOT fi ll past the MAX level indicated on the Water Level

Window. Overfi lling may cause water to spill out when boiling.

3. Place Kettle on Base making sure it is correctly engaged on its Base.

4. Plug Power Base cord into a 120V AC wall outlet.

NOTE: Never plug Power Base with empty Kettle into the electrical

outlet.

5. Depress the On/Off Switch to the 'On' position. The Indicator Light

will illuminate to indicate that the Kettle is in the boil cycle. Once the

water has boiled, the On/Off Switch will automatically switch to the

'Off' position and the Indicator Light will go out.

NOTE: Direct kettle spout away from cabinets, walls, etc. to prevent

possible steam damage.

6. If you want to use the Kettle again, allow the thermal safety switch

to cool down for 15 – 20 seconds then depress the On/Off Switch to

the 'On' position. If the On/Off Switch does not remain in the 'On'

position, the Water is hot enough to use without reheating.

7. Unplug cord from wall outlet before lifting Kettle from Power Base.

Grip the Kettle by the Handle only, as the surface and lid will be hot.

8. Return the Kettle to the Power Base or place on a heat resistant

surface after use.

9. If the Kettle is accidently switched on when empty, the thermostat

will automatically shut it off to prevent the Kettle from overheating.

If this situation occurs, unplug the Power Base and let the Kettle

cool before refi lling.

10. It is recommended that the power cord be disconnected from the

wall outlet when not in use. DO NOT attempt to connect any other

appliance to the Power Base or tamper with the connector in any

way.

CARE AND CLEANING

Installing the Filter

Drop the fi lter into the spout with the smallest part towards the bottom

of the spout. Gently push the top edge of the plastic fi lter frame against

the kettle. You will hear the fi lter snap into position.

Removing the Filter

Gently push the fi lter out into the spout from the inside of the kettle.

NEVER INSTALL OR REMOVE THE FILTER WHEN THE KETTLE IS HOT.

JK1250_Booklet.indd 4

6/11/15 11:47 PM

Table of Contents