Rear Panel - Siemens SpeedStream SS2624 User Manual

Rear Panel

Printer Port
Aerial Antenna
Reset Button
WAN port
(10BaseT)
10/100BaseT
LAN connectors
Normal/Uplink
Button- Optional
Figure 2: Rear Panel
Standard parallel printer port. If you wish to share a printer, connect it
here.
Best results are usually obtained with the antenna in a vertical position.
This button has three (3) functions:
Reboot. When pressed and released, the DSL/Cable Router will
reboot (restart).
Diagnostic print-out. If held down for 3 seconds, a diagnostic
print-out will be sent to the attached printer.
Ensure the printer is ready.
Both Print LEDs will flash simultaneously during the diag-
nostic printing.
Reset to Factory Defaults. This button can also be used to clear
ALL data and restore ALL settings to the factory default values.
To Clear All Data and restore the factory default values:
1. Power Off the router
2. Hold the Reset Button down while you Power On the router.
3. Continue holding the Reset Button until the Status (Red) LED
blinks TWICE.
4. Release the Reset Button.
The factory default configuration has now been restored, and the
Router is ready for use.
Connect the DSL or Cable Modem here. If your modem came with a
cable, use the supplied cable. Otherwise, use a standard CAT5 UTP
LAN cable.
Use standard LAN cables (RJ45 connectors) to connect to your PCs.
Both 10BaseT and 100BaseT connections can be used simultaneously.
If no Uplink push-button is present, all 4 LAN ports are capable of
being connected to a hub with a straight-through cable.
If an Uplink button is present, see the "Normal/Uplink" button
function below.
If this button is present, it allows LAN port 1 to be used as an Uplink
port for connecting directly to another hub.
When depressed (in), then the "LAN 1" port becomes an "Uplink" port,
and must be connected to a normal port on another Hub.
If this button is extended (out), then the "LAN 1" port acts as a normal
LAN port.
Introduction
5