Removing And Installing Identification Caps; Troubleshooting - Shure BLX1 User Manual

Removing and Installing Identification Caps

The BLX2 is equipped with a black identification cap from the factory (dual vocal systems ship with additional gray
cap).
To remove: Remove battery cover. Squeeze sides and pull off cap.
To install: Align the cap and click into place. Replace battery cover.
An Identification Cap Kit containing assorted colored caps is available as an optional accessory.

Troubleshooting

Issue
No sound or faint sound
Indicator Status
Receiver ready LED on
Receiver ready LED off
Receiver LED screen off
Solution
• Verify all sound system connections or adjust
gain as needed (see Adjusting Gain)
• Verify that the receiver is connected to mixer/
amplifier
• Turn on transmitter
• Make sure the batteries are installed
correctly
• Perform transmitter setup (see Single
System Setup)
• Insert fresh batteries
• Make sure DC adapter is securely plugged
into electrical outlet.
• Make sure receiver is powered on.
Shure Incorporated
14/25