Recording On A Cd-R Or Cd-Rw Disc Manually - Sony RCD-W7V Operating Instructions Manual

Notes
• You cannot record over existing material. The
recorder automatically starts recording from the
end of the existing material.
• Make sure that the remaining recordable time on
the CD-R or CD-RW is longer than the playing
time of the CD, especially if you want to record all
the tracks on the CD.
• You cannot pause recording in Synchro-Recording.
• If you set "Program Play," you cannot use the High
Speed Synchro-Recording mode for recording.
• When you select the High Speed Synchro
Recording mode during Program Play, the recorder
will automatically make a copy at normal speed.
• You cannot use the recording function when you set
"Shuffle Play."
• If an error message appears on the front panel
display, refer to "Error Messages" on page 55.
• With the following kinds of CDs, you may
experience a reading failure or noise when recorded
to a CD-R or CD-RW.
– CD with adhesive labels attached to them
– Irregularly shaped CDs (for example, heart or star
shaped)
– CDs with printed text concentrated on one side
only
– Old CDs
– Scratched CDs
– Dirty CDs
– Warped CDs
• When "TOC WRITE" flashes in the display, the
recorder is currently updating the table of contents
(TOC). Do not move the recorder or pull out the
AC power cord.
• If the following occurs during CD playback or
recording, a reading error may occur or noise may
be produced in the recorded results:
– The CD tray or other part of the system is bumped.
– The system is placed on an uneven or soft surface.
– The system is located near a speaker, door, or other
source of vibration.
Do not disconnect the recorder from
the power source immediately after
recording.
If you do, recorded material may not be
saved to the CD-R or CD-RW. When
"BUSY" or "UPDATE" appears in the
display, the deck is currently updating track
information. When "UPDATE" stops being
displayed, it is safe to disconnect the AC
power cord.
US
48
*RCD-W7V.p65_46-53
Recording on a CD-R or
CD-RW disc Manually
You can start recording from the end of the
existing material.
When using the remote, set SELECT to
DECK B for operations on DECK B.
To perform Synchro-Recording, see
"Recording a CD to CD-R or CD-RW disc
at Normal Speed" on page 46 or "Recording
a CD to CD-R or CD- RW disc at High
Speed" on page 46.
1
2
3
To record through
DIGITAL OPTICAL IN OPTICAL
ANALOG IN
4
Note
The manual recorording from DECK A is not
available, so use syncro recording method. Refer to
page 46-47.
48
INPUT
z
Turn on the amplifier and set the
input selector to the position for the
sound source you want to record.
Place a recordable CD-R or CD-RW
on DECK B.
Press INPUT repeatedly to select
the input connector.
Select
ANALOG
Press REC z z z z z .
The recorder stands by for recording.
12/9/01, 6:10 PM
RCD-W7V 4-236-407-11(1)
REC z
REC LEVEL