Connecting The Pc - Panasonic KX-TDE200 Getting Started

3.2

Connecting the PC

The Maintenance Console serves as an overall system programming tool for the PBX. The Maintenance
Console's Quick Setup lets you easily configure the PBX to receive intercom and trunk calls, as well as apply
basic settings such as time and date.
To programme the PBX, connect it to the PC via the MNT or RS-232C port.
PC Connection
To LAN Port
PC
To COM Port
PC
Pin Assignments
LAN (RJ45 Cable)
LAN Port (PC)
Pin No.
1
2
3
6
IMPORTANT
• When connecting a PC to the PBX via the MNT port, a fixed IP address must be assigned to
the PC. For information about fixed IP addresses, ask your network administrator.
• When connecting a PC to the PBX via the RS-232C port, it is necessary to keep the following
in mind to protect the system:
1.
Make sure that both connector cases (frame ground) of the RS-232C cross cable
(shielded cable) are conductive. If they are not conductive, make sure that both
connector cases of the cable are firmly connected.
2.
If this is not possible, connect the frame of the PBX to the frame of the PC using an
earthing wire in order to prevent difference in the electrical potentials.
MNT Port
RS-232C Port
MNT Port (PBX)
Pin No.
1
2
3
6
RS-232C (Cross Cable)
COM Port RS-232C Port
Pin No.
2
3
4
5
6
7
8
3.2 Connecting the PC
To attach the ferrite core
3 cm
Pin No.
2
3
4
5
6
7
8
Getting Started for Physical Cards 19