Connecting The Pc - Panasonic KX-TDE100 Getting Started

WWW.ERTEBATGROUP.COM

3.2 Connecting the PC

The Maintenance Console serves as an overall system programming tool for the PBX. The Maintenance
Console's Quick Setup lets you easily configure the PBX to receive intercom and trunk calls, as well as apply
basic settings such as time and date.
To programme the PBX, connect it to the PC via the MNT or RS-232C port.
PC Connection
To LAN Port
PC
To COM Port
PC
Pin Assignments
LAN (RJ45 Cable)
LAN Port (PC)
Pin No.
1
2
3
6
CAUTION
When connecting a PC to the PBX via the RS-232C port, it is necessary to keep the following in mind to
protect the system:
1.
Make sure that both connector cases (frame ground) of the RS-232C cross cable (shielded cable) are
conductive. If they are not conductive, make sure that both connector cases of the cable are firmly
connected.
2.
If this is not possible, connect the frame of the PBX to the frame of the PC using an earthing wire in
order to prevent difference in the electrical potentials.
Notice
When connecting a PC to the PBX via the MNT port, a fixed IP address must be assigned to the PC. For
information about fixed IP addresses, ask your network administrator.
MNT Port
RS-232C Port
MNT Port (PBX)
Pin No.
1
2
3
6
WWW.ERTEBATGROUP.COM
RS-232C (Cross Cable)
COM Port RS-232C Port
Pin No.
2
3
4
5
6
7
8
3.2 Connecting the PC
To attach the ferrite core
3 cm
Pin No.
2
3
4
5
6
7
8
Getting Started for Physical Cards 21