Troubleshooting - Bissell Spot Lifter 1718 Series User Manual

M
aintenance and care (continued)
Machine storage
1.
Clean exterior surface of Spot Lifter with a soft
cloth dampened with water only. Do not use a
strong detergent or other cleaners as this may
damage the finish.
2.
Store Spot Lifter in a protected dry area, at room
temperature (40° - 110°F).
Battery removal and disposal
1.
Important: Unplug charger.
2.
Remove tanks (front and rear) and discard.
3.
Remove screws (6) holding product housing
together.
4.
Use screwdriver to score rating label on bottom
of unit.
5.
Separate housings and locate battery pack in
bottom/ center of unit.
6.
Remove wire connectors from the battery pack.
7.
Keep battery pack together - DO NOT separate
individual batteries. For specific disposal
instructions of batteries, please contact:
RBRC (Rechargeable Battery Recycling
Corporation)
1-800-822-8837.
8.
Discard remainder of product.
T
roubleshooting
Reduced Suction / No Suction
Possible Cause
1. Collection tank is full
2. Collection tank drain plug is loose
3. Batteries weak/undercharged
4. Collection tank not properly installed
w w w . b i s s e l l . c o m
ug603-5410_1719_806.indd 9 ug603-5410_1719_806.indd 9
WARNING:
This product contains a
rechargeable nickel cadmium
battery (sometimes referred
to as a "Ni-Cad" battery)
pack. The average life of a
Ni-Cad battery is 5-7 years,
depending on frequency of
use. According to Federal
regulations, proper removal
and disposal of Ni-Cad
batteries are required.
3.
Screws
WARNING:
To reduce the risk of fire,
electric shock or injury,
unplug appliance from
outlet before servicing.
Remedies
1. Empty collection tank
2. Check plug for snug fit
3. Recharge according to instructions
4. Snap tank into place
8 0 0 . 2 3 7 . 7 6 9 1
9
9/25/06 1:07:42 PM 9/25/06 1:07:42 PM