Table of Contents
Advertisement
NAME OF PARTS
Remote controller
Display panel
1 "MODE" button
2 "10 °C HEAT" button
3 "SET TEMP." button (
4 "ECONOMY" button
5 "SLEEP" button
6 "FAN" button
7 "START/STOP" button
8 "SET" button (Vertical)
9 "SET" button (Horizontal)
0 "SWING" button
A "TIMER MODE" button
B "TIMER" Set (
C "CLOCK ADJUST" button
D "RESET" button
E "TEST RUN" button
This button is used when installing the air
●
conditioner, and should not be used under
normal conditions, as it will cause the air
conditioner's thermostat function to operate
incorrectly.
●
If this button is pressed during normal
operation, the unit will switch to the Test
Run mode, and the indoor unit's Operation
indicator lamp and Timer indicator lamp will
begin to blink simultaneously.
●
To stop the Test Run mode, press the
"START/STOP" button to stop the air
conditioner.
/
)
/
) button
Display panel
To facilitate explanation, the accompanying illustration
has been drawn to show all possible indicators; in actual
operation, however, the display will only show those
indicators appropriate to the current operation.
F Signal transmitter
G Temperature set indicator
H Operating mode indicator
I [SLEEP] indicator
J Transmit indicator
K Fan speed indicator
L Swing indicator
M T imer mode indicator
N Clock indicator
Some indoor units may not be equipped with the functions
corresponding to all of the buttons on this remote
controller. The indoor unit will beep and the Operation
indicator lamp, Timer indicator lamp and Economy
indicator lamp blink when a remote controller button is
pressed if the function is not available.
En-4
Advertisement
Table of Contents
