Asus WS C246M PRO Manual page 98

The following items appear only when BMC Support is set to [Enabled].
Wait for BMC [Disabled]
Allows you to enable or disable wait for BMC response for specified time out.
Configuration options: [Disabled] [Enabled]
FRB-2 Timer [Enabled]
Allows you to enable or disable FRB-2 timer (POST timer).
Configuration options: [Disabled] [Enabled]
FRB-2 Timer timeout [6 minutes]
Allows you to select the FRB-2 Timer Expiration value.
Configuration options: [3 minutes] [4 minutes] [5 minutes] [6 minutes]
FRB-2 Timer Policy [Do Nothing]
Allows you to select the how the system should respond in FRB-2 Timer expires.
Configuration options: [Do Nothing] [Reset] [Power Down] [Power Cycle]
OS Watchdog Timer [Disabled]
This item allows you to start a BIOS timer which can only be shut off by Management
Software after the OS loads.
Configuration options: [Disabled] [Enabled]
The following items are configurable only when OS Watchdog Timer is set to [Enabled].
Serial Mux [Disabled]
Allows you to enable or disable Serial Mux configuration.
Configuration options: [Disabled] [Enabled]
BMC Warm Reset
This item allow you to perform a BMC warm reset.
3-40
OS Wtd Timer Timeout [10 minutes]
Allows you to configure the length for the OS Boot Watchdog Timer.
Configuration options: [5 minutes] [10 minutes] [15 minutes] [20 minutes]
OS Wtd Timer Policy [Reset]
This item allows you to configure the how the system should respond if the
OS Boot Watch Timer expires.
Configuration options: [Do Nothing] [Reset] [Power Down] [Power Cycle]
Chapter 3: BIOS Setup