Table of Contents
Advertisement
TOC Edit
• The MD player is recording information (track start and end
position) from the memory to the disc.
— Wait until this process is completed. Do not expose the player to
physical shock, nor disrupt power supply.
BUSY
• You tried to operate the recorder while it was accessing the
recorded data.
— Wait until the message goes out (in rare cases, it may take 2 - 3
minutes).
NAME FULL
• You tried to enter more than 200 letters to label a single track or
disc.
• You tried to enter a total of more than 1700 letters for track or disc
names.
— Enter the characters within the limit.
Hi DC in
• Voltage of the power supply is too high (The supplied AC power
adaptor is not used).
— Use the supplied AC power adaptor.
HOLD
• The recorder is locked.
— Move HOLD against the arrow to unlock the recorder (pages 10,
37).
LOW BATT
• Battery is weak.
— Charge the rechargeable battery or replace the dry battery
(page 9).
MEM OVER
• You tried to record with the recorder placed where it receives
continuous vibration.
— Put the recorder on a stable place, and start recording again.
NO COPY
• You tried to make a copy from a disc that is protected by the Serial
Copy Management System. You cannot make copies from a
digitally connected source which was itself recorded using digital
connection.
— Use analog connection instead (page 20).
61
-GB
Advertisement
Table of Contents
