Miscellaneous; Charge - VDO TPMS Go User Manual

UM-HV1-13-11

1. CHARGE

Low Battery Indication
Your TPMS TOOL incorporates a low battery
detection circuit. Battery life is an average of 400
sensor tests per
(approximately 80-100 cars).
A full charge takes about 6 hours.
When battery is low, the battery screen is
flashing with the message "LOW".
The power button my also be pressed and held
for a second to display battery status.
Battery Charging
When the battery is low, the "status bar" appears every 10 seconds. The display turns off
when the battery loses power.
Plug the USB cable between the tool and the charger adapter, and then plug the charger
adapter to an appropriate outlet. The red LED "CHARGE" light will turn on.
It's not recommended to use the tool with low
battery status as the transmission and emission
may not be reliable.
Once charged, the bar graph is full and the LED
"CHARGE" turns to green light.
Battery replacement
The tool must be returned to the factory for battery replacement.
Opening the tool or tampering with the seal placed on the tool will void the
warranty.
Page 26/32

MISCELLANEOUS

battery full charge
supply connector
VDO TPMS GO user guide
BATTERY
BATTERY
USB Power
BATTERY
LEVEL
LEVEL
LOW
Fig. 6
LEVEL