Hamilton Beach HMD300 Operation Manual page 7

Care and Cleaning of the Mixer
Cleaning and Sanitizing the Container, Spindle, and Agitator
Cleaning
1. Place a drop of detergent and 1 cup of water
into a mixing container.
2. Position the container under the mixing spindle
and mix on low speed (I) for 5 seconds. Empty
the mixing container.
3. Place 1 cup of clean water into a container and
repeat mix for 5 seconds to rinse.
NOTE: Inspect agitator(s) daily. Replace agitator(s)
every 90 days.
Cleaning the Container Guide, Container Rest, and Housing
Electrical Shock Hazard.
w WARNING
Disconnect power before cleaning. Failure to do
so can result in death or electrical shock.
Cleaning the Container Guide,
Container Rest, and Housing
1. Unplug mixer.
2. Remove the container guide (see page 6).
3. Wash the container guide with hot, soapy water;
then rinse.
4. Clean the housing, front panel, and container
rest with a damp, soapy cloth.
5. Wipe dry with a clean, soft cloth.
6. Reinstall the container guide.
NOTE: Do not spray or submerge the mixer.
Any resulting water damage will not be covered
by the warranty.
7. Plug mixer into a grounded outlet.
Sanitizing
For best results, use the Hamilton Beach Universal
Container (#110E).
1. Fill the container with sanitizing solution
(1 tablespoon [15 ml] of household bleach per 1
gallon of water at 50°–70°F [10°–21°C]) to
Position the container under the mixing spindle
and run on low speed (I) for 1 minute.
2. Remove container. Empty sanitizing solution and
rinse container.
3. To dry, run the mixer on low speed (I) for 30
seconds with empty container in place. DO NOT
RINSE after sanitizing is completed.
NOTE: If preferred, the container and agitator may
be cleaned in a dishwasher.
3 ⁄ full.
4
7