On Cleaning Discs - Sony DAV-LF10 Operating Instructions Manual

• For power saving purposes, set the system to standby
mode by pressing the "/1 button (the standby
indicator lights up). To turn off the system
completely, remove the AC power cord (mains lead)
from the wall outlet (mains).
• Do not carry the system while it is turned on.
On adjusting volume
Do not turn up the volume while listening to a section
with very low level inputs or no audio signals. If you
do, the speakers may be damaged when a peak level
section is suddenly played.
On cleaning
Clean the cabinet, panel, and controls with a soft cloth
slightly moistened with a mild detergent solution. Do
not use any type of abrasive pad, scouring powder or
solvent such as alcohol or benzine.
If you have any questions or problems concerning your
system, please consult your nearest Sony dealer.

On cleaning discs

Do not use a commercially available CD/DVD
cleaning disc. It may cause a malfunction.
On your TV's color
If the speakers should cause the TV screen to have
color irregularity, turn off the TV at once then turn it
on after 15 to 30 minutes. If color irregularity should
persist, place the speakers farther away from the set.
The nameplate is located on the rear of the unit.
IMPORTANT NOTICE
Caution: This system is capable of holding a still
video image or on-screen display image on your
television screen indefinitely. If you leave the still
video image or on-screen display image displayed
on your TV for an extended period of time you risk
permanent damage to your television screen.
Projection televisions are especially susceptible to
this.
On moving the system
When you carry the system, use the following
procedure to protect the inner mechanism.
1
Make sure that a disc is removed from the
system.
2
Press FUNCTION on the remote or touch
the Touch Panel (page 43) repeatedly to
select "DVD."
GB
4
3
Touch the Touch Panel Sensor .
(page 43) and Z of the control unit
simultaneously for a few seconds until the
front panel display changes to "Mecha
Lock." If some messages other than "Mecha
Lock" appear, ignore them.
To cancel, press "/1.
4
Remove the AC power cord (mains lead)
from the wall outlet (mains).
Note
Do not handle the clear plastic panel when you move
or operate the control unit as it may break.