Sony DAV-LF10 Operating Instructions Manual page 32

Hanging the IR transmitter and IR receiver on a wall
You can hang the IR transmitter and IR receiver on a wall when:
– there is an obstruction between the IR transmitter and the IR receiver.
– people often pass between the IR transmitter and the IR receiver.
When hanging both the IR transmitter and IR receiver, adjust the position of the IR transmitter after
deciding the position of the IR receiver.
To hang the IR receiver on a wall
1
Prepare a screw (not supplied) that is
suitable for the hole on the back of the
IR receiver. See the illustrations below.
2
Fasten the screw to the wall. The screw
should protrude 4 mm (
GB
32
3 mm
1
(
more than 20 mm
13
( / inch)
16
3.5 mm
5
( / inch)
32
8 mm
11
( / inch)
32
Hole on the back
of the IR receiver
3
/ inch).
16
4 mm
3
( / inch)
16
3
Detach the IR receiver stand and hang
it via hole on the rear side of the IR
receiver on the screw.
Make sure that the IR receiver does not
move after installation.
/ inch)
8
Tip
When reattaching the IR receiver stand to the IR
receiver, attach the stand so that both delta marks on
the IR receiver and stand are aligned (page 16).
Hole on the back
of the IR receiver
3.5 mm
5
( /
8 mm
IR receiver
11
(
IR receiver stand
inch)
32
/ inch)
32