Settings For The Hdmi - Sony DAV-HDX277WC Operating Instructions Manual

Home theater systems: bravia® theater system with s-air® client
Hide thumbs Also See for DAV-HDX277WC:
Table of Contents

Advertisement

The system outputs the progressive signal
for 5 seconds. Check that the screen is
displayed correctly.
3
Press C/c to select [YES].
The system outputs the progressive signal.
If you select [NO], the system will not
output the progressive signal.
Note
• [PROGRESSIVE (COMPONENT OUT)] is
effective only when you connect the unit and TV with
a component video cord (page 28).
x [4:3 OUTPUT]
When you use a 16:9 aspect ratio TV, you can
adjust the aspect ratio to watch 4:3 aspect ratio
signals. If you can change the aspect ratio on
your TV, change the setting on your TV, not the
system.
[FULL]: Select this when you can change the
aspect ratio on your TV.
[NORMAL]: Select this when you cannot
change the aspect ratio on your TV. A 16:9
aspect ratio signal with black bands on left and
right sides of the image appears.
Note
• [4:3 OUTPUT] is effective only when you set [TV
TYPE] in [VIDEO SETUP] to [16:9].
x [BLACK LEVEL]
You can select the black level (setup level) for
the video signals output from the jacks other
than COMPONENT VIDEO OUT/HDMI OUT.
[ON]: The standard level.
[OFF]: You can lower the standard black level.
Use this when the picture becomes too white.
x [BLACK LEVEL (COMPONENT OUT)]
You can select the black level (setup level) for
the video signals output from the
COMPONENT VIDEO OUT jacks.
70
US
16:9 aspect ratio TV
You cannot select this and the setting is not
effective when the system outputs progressive
signal.
[OFF]: You can set the black level of the output
signal to the standard level.
[ON]: You can raise the standard black level.
Use this when the picture becomes too black.
x [PAUSE MODE] (DVD VIDEO/DVD-R/
DVD-RW only)
You can select the picture in pause mode.
[AUTO]: The picture, including subjects that
move dynamically, is output with no jitter.
Normally select this position.
[FRAME]: The picture, including subjects that
do not move dynamically, is output in high
resolution.

Settings for the HDMI

[HDMI SETUP]
HDMI SETUP
HDMI RESOLUTION:
CONTROL FOR HDMI:
VOLUME LIMIT:
YC
C
/RGB(HDMI):
B
R
AUDIO(HDMI):
JPEG RESOLUTION:
x [HDMI RESOLUTION]
You can select the type of video signal that is
output from the HDMI OUT jack. For details,
see "To select the type of video signal output
from the HDMI OUT jack" (page 46).
[AUTO (1920
1080p)]: The system outputs
×
the optimal video signal for the connected TV.
[1920
1080i]: The system outputs 1920 ×
×
1080i* video signals.
[1280
720p]: The system outputs 1280 ×
×
720p* video signals.
[720
480p]**: The system outputs 720 ×
×
480p* video signals.
* i: interlace, p: progressive
AUTO
(1920x1080p)
OFF
LEVEL2
YC
C
B
R
OFF
SD

Advertisement

Table of Contents
loading

Table of Contents