Settings For The Hdmi - Sony DAV-DZ670M Operating Instructions Manual

x [BLACK LEVEL]
(North American, Mexican, and Latin
American models only)
You can select the black level (setup level) for
the video signals output from the jacks other
than COMPONENT VIDEO OUT/HDMI OUT.
[ON]: The standard level.
[OFF]: You can lower the standard black level.
Use this when the picture becomes too white.
x [BLACK LEVEL (COMPONENT OUT)]
(North American, Mexican, and Latin
American models only)
You can select the black level (setup level) for
the video signals output from the
COMPONENT VIDEO OUT jacks.
You cannot select this and the setting is not
effective when the system outputs progressive
signal.
[OFF]: You can set the black level of the output
signal to the standard level.
[ON]: You can raise the standard black level.
Use this when the picture becomes too black.
x [PAUSE MODE] (DVD VIDEO/DVD-R/
DVD-RW only)
You can select the picture in pause mode.
[AUTO]: The picture, including subjects that
move dynamically, is output with no jitter.
Normally select this position.
[FRAME]: The picture, including subjects that
do not move dynamically, is output in high
resolution.

Settings for the HDMI

[HDMI SETUP]
HDMI SETUP
HDMI RESOLUTION:
CONTROL FOR HDMI:
VOLUME LIMIT:
YC
AUDIO(HDMI):
JPEG RESOLUTION:
62
GB
AUTO
C /RGB(HDMI):
B R
x [HDMI RESOLUTION]
You can select the type of video signal that is
output from the HDMI OUT jack. For details,
see "To select the type of video signal output
from the HDMI OUT jack" (page 36).
[AUTO (1920
the optimal video signal for the connected TV.
[1920
1080i* video signals.
[1280
720p* video signals.
[720
×
480p* video signals.
* i: interlace, p: progressive
** Depending on the country model, [720 × 576p] may
appear.
x [CONTROL FOR HDMI]
You can set the [CONTROL FOR HDMI]
function to on/off. This function is available
when you connect the system and TV with an
HDMI cable. For details, see "Using the Control
for HDMI Function for "BRAVIA" Sync"
(page 71).
[OFF]: Off.
[ON]: On. You can operate mutually between
components that are connected with an HDMI
cable.
Note
• When you set to [ON] without the HDMI connection
of the TV, [Please verify the HDMI connection.]
appears and you cannot set to [ON].
x [VOLUME LIMIT]
If you change the output method of the TV to the
system speaker on the TV menu or by pressing
THEATRE, the System Audio Control
(page 73) is activated and loud sound may be
output depending on the volume level of the
system. You can prevent this by limiting the
(1920x1080p)
maximum level of the volume.
OFF
LEVEL2
YC C
B R
[LEVEL3]: Maximum volume level is set to 10.
OFF
[LEVEL2]: Maximum volume level is set to 15.
SD
[LEVEL1]: Maximum volume level is set to 20.
[OFF]: Off.
1080p)]: The system outputs
×
1080i]: The system outputs 1920 ×
×
720p]: The system outputs 1280 ×
×
480p]**: The system outputs 720 ×