Fujitsu PRIMERGY 10/40GbE Connection Blade 18/8+2 Function Manual page 23

"lan ip filter", "qos aclmap", "vlan qos aclmap", "lan ip dscp", "ip6filter", "vlan ip6filter", "lan ip6 filter",
"ip6qos aclmap", "vlan ip6qos aclmap", "lan ip6 dscp" commands.
- The priority level between ether ports becomes high though the ether port number is smaller.
- The priority level between VLAN becomes high though the VLAN ID is smaller.
The number of masks which "macfilter", "vlan macfilter", "lan ip filter", "qos aclmap", "vlan qos aclmap",
"lan ip dscp", "ip6filter", "vlan ip6filter", "lan ip6 filter", "ip6qos aclmap", "vlan ip6qos aclmap", "lan ip6
dscp" commands consumes are as follows depending on applied acl.
When multiple acl are applied it will be the sum total of each and the total of each by combination will be as
follows.
Condition of applied acl
In case of acl mac definition
In case of acl vlan definition
In case of acl ip definition
When srcIP address is not specified
When tos value/ dscp value is not specified
When tos value/ dscp value is specified
When srcIP address is specified
When dstIP address is not specified
When dstIP address is specified
When mask value of srcIP and dstIP are same
When mask value of srcIP and dstIP is
different.
In case of acl ip6 definition
When srcIP address is not specified
When tc value/ dscp value is not specified
When tc value/ dscp value is specified
When srcIP address is specified
When dstIP address is not specified
When dstIP address is specified
When tc value/ dscp value is not specified
When tc value/ dscp value is specified
The number of masks which "vlan protocol" command consumes are as follows.
Condition of applied acl
In case of protocol VLAN definition
When vlan protocol ipv4 is specified
When vlan protocol ipv6 is specified
When vlan protocol <count> ether is specified
Upper limit according to number of actions:
- When CEE function is used, 15 devices
- When CEE function is not used, 16 devices
Setting is possible to the upper limit by number of actions in addition with "qos aclmap", "vlan qos
aclmap", "lan ip dscp", "ip6qos aclmap", "vlan ip6qos aclmap", "lan ip6 dscp", "vlan protocol" commands.
The priority level is respectively as follows.
- The applied priority order of command is the order of "vlan protocol", "qos aclmap", "vlan qos
When tos value/ dscp value is not
specified
When tos value/ dscp value is
specified
Number of
masks
1
1
1
3
1
1
3
3
1
3
3
3
5
Number of
masks
3
1
1
Page 23 of 71