Table of Contents
Advertisement
AC5200 Configuration
3
AC5200 Configuration
3.1
Upgrading an Entro SR34i or SR35i
12
Siemens AB
Security Products
This chapter outlines the configuration steps required to connect an AC5200 with
SiPass integrated.
This section only applies if you are upgrading Entro controllers in the field to ACC-
X units.
Requirements:
SAN-Disk Compact Flash card.
ACC-X Firmware upgrade file.
To upgrade an Entro Controller to an ACC-X:
1.
Determine the version of Entro firmware currently running. This can be found
on the Status screen of the Entro Software running on the PC
It can also be found on the LCD menu interface of the SR34i/SR35i.
–
2.
Select the appropriate upgrade file as specified in the table below. This file
can be found on the CD in the Firmware\ACC\ACC-X folder.
3.
Copy this file to the Compact Flash card.
Entro Firmware Version
Earlier versions
5.2
5.25
5.3
4.
Determine the IP address of the SiPass integrated Server PC, and record it.
5.
Use the LCD menu on the SR34i/SR35i to determine the current IP address,
gateway, subnet mask and door count, and make a note of these values
(write it down on paper or otherwise record the values as they will be needed
later).
6.
Carefully Insert the Compact Flash card into the SR34i/SR35i controller unit.
7.
Answer yes when the LCD menu asks "Upgrade to new firmware?".
8.
Wait for the LCD menu to confirm that it has completed the upgrade (this usu-
ally takes several minutes) and then remove the Compact Flash card.
9.
Wait a moment for the ACC-X firmware to get running.
10. Make a note of the serial number displayed.
11. Use the LCD menu to re-enter the IP address, gateway, subnet mask and
Server IP address.
12. Repeat steps 4-11 for each controller
Renamed ACC-X upgrade file
patch.dat
patch_SR34i.dat
SR_firmware.hex (upgrade path to 5.3)
SR_firmware.hex (allows > 1Meg files)
10.2013
Hide quick links:
Advertisement
Table of Contents
