Table of Contents
Advertisement
2
Fix the gap between the decoration panel and the unit if
necessary. (See figure 10)
Precautions
Improper tightening of the screws (see figure 4) may cause air to
■
leak into the unit and between the ceiling and the decoration
panel (1) resulting in formation of contamination (2) and dew (3).
If there is a gap remaining between the ceiling and the
■
decoration panel after tightening the screws, re-adjust the indoor
unit body height (see figure 9). Adjustment of the indoor unit
body height is possible through the holes in the corners of the
decoration panel. The indoor unit must be kept levelled and the
drain piping kept unaffected.
3
Wiring of the decoration panel (See figure 8)
Make sure to turn off the power supply before wiring!
1
Swing flap motor lead wire
2
Connector
3
Electric components box lid
4
Hooks
5
Screw (2 locations)
6
Clamp
■ Remove the electric components box lid.
Loosen the 2 screws, slide the electric components box lid in
the direction of the arrows and disengage it from the hooks.
■ Securely connect the connectors for swing flap motor lead
wire installed on the decoration panel.
■ Securely fix the swing flap motor lead wire with the supplied
clamp.
■ Replace the electric components box lid reversing the
procedure to remove it.
Do NOT over tight screws during assembling pro-
NOTE
cess to avoid any damage.
Make sure that the swing flap motor lead wire is not
caught between the indoor unit and the decoration
panel and in between the electric component box lid.
Installation manual
2
Installation of the suction grille and the
corner decoration cover
Install the suction grille
Install the suction grille by reversing the procedure shown in
paragraph "Preparing the decoration panel for installation" on page 1.
Return the suction grille hooks on the decoration panel.
■
Close the suction grille and lock the suction grille knobs by
■
pushing them outward.
It is possible to install the suction grille in 4 directions by simply
■
turning it 90 degrees.
Change the direction when adjusting the direction of the suction
■
grille of multiple units or to comply with demands of the
customer.
Make sure that strings are not hanging out in
NOTE
between the decoration panel and the suction
grille.
Install the corner decoration cover
(See figure 7)
1
Attach the string of each corner decoration cover to the pin of
the decoration panel.
When the corner decoration cover gets loose
NOTE
during maintenance of the decoration panel of the
indoor unit, the string prevents the corner
decoration cover from falling on the floor and
getting damaged.
2
Install each corner decoration cover.
■ First insert the hook at the square tip of the corner decoration
cover into the hole at the decoration panel corner.
■ Then position the 4 latches of the corner decoration cover to
fit into the holes of the decoration panel and gently push the
corner decoration cover onto the decoration panel.
BYCQ140E2P + BYCQ140E2PB
Designer Decoration panel
4P561932-1 2018.12
Advertisement
Table of Contents
