Connecting The Processor To Analogue Components - Sony MDR DS4000 Operating Instructions Manual

Connecting cables (sold separately)
Use the Optical digital connecting cable POC-20AP (mini-plug y rectangular plug) when
connecting the optical digital output mini-jack on portable DVD players, portable CD players, or
other digital components to the DIGITAL IN jack.
Optical digital selector (sold separately)
Use of the optical digital selector SB-RX100P (4-line input, 3-line output) is recommended when
connecting more than one digital component.
Notes on optical digital connecting cable
• Do not drop objects on the optical digital connecting
cable or expose the cable to shock.
• Grasp the plug to connect or disconnect the cable.
• Be sure that the ends of the optical digital connecting
cable are kept clean. Dust at the ends of the cable can
degrade performance.
• When storing the system, attach the cap to the end of the plug
and be careful not to fold or bend the optical digital
connecting cable with a bend radius less than 25 mm (1 inch).
Connecting the processor to analogue
components
Use an audio cord (sold separately) to connect to the audio output jacks on a VCR,
TV, or other component to the LINE IN (L/R) jacks on the processor.
Processor
Connecting cables (sold separately)
Use the connecting cable RK-G129 (stereo mini-plug y pin plug
mini-jack (line out jack or headphones jack) to the LINE IN jacks.
In this case, set the volume on the player at a medium level. Noise can occur if the volume on the
player is set too low.
See "Specifications: Recommended accessories" (page 27) for details about other connecting
cables (sold separately).
GB
14
Connection
To LINE IN jacks
Audio left (L, white)
Audio right
(R, red)
Audio cord
(sold separately)
The bend radius of the optical
digital connecting cable should be
no less than 25 mm (1 inch).
To audio output jacks
Audio left (white)
Audio right (red)
2) when connecting a stereo
25 mm
(1 inch)
VCR, TV, or other
component