Connecting A Vcr And Cable Tv - Sony WEGA KE 42M1 Operating Instructions Manual

Connecting a VCR and Cable TV

75-ohm
coaxial cable
(supplied)
VCR
AUDIO cable (not supplied)
Use this hookup if:
• You subscribe to a cable TV system that does not require a cable box.
Disconnect all power sources before making any connections.
1
Connect the CATV cable to the VCR's IN jack.
2
Using the supplied 75-ohm coaxial cable, connect the VCR's OUT jack
to the TV's VHF/UHF jack.
3
Using AUDIO and S VIDEO cables, connect the VCR's AUDIO and S
VIDEO OUT jacks to the TV's AUDIO and S VIDEO IN jacks (VIDEO IN
1 or 3).
S VIDEO
VIDEO (yellow)
Cable
AUDIO-L (white)
AUDIO-R
S VIDEO cable
(not supplied)
Note
When you connect video equipment to both the VIDEO and the S VIDEO input jacks, make sure
"Auto YC" in the (Setup) menu is set to "On" to view the S VIDEO input (see below).
Tips
• You can also use the VIDEO IN 2 jacks located on the front of the TV to connect your VCR.
• If your VCR is not equipped with S VIDEO, use a VIDEO cable (yellow) instead of the S
VIDEO cable.
When connecting both VIDEO IN and S VIDEO IN
Using the menu, you can select the jack from which the TV receives the input
signal. You can set it for each video input (VIDEO IN 1, VIDEO IN 2 and
VIDEO IN 3) separately. The TV is factory set to receive S VIDEO input signals.
1
Press VIDEO 1/2/3 repeatedly until the desired video input appears.
2
Press MENU.
3
Press V/v to select
4
Press V/v to select "Auto YC," then press
5
To watch the pictures input from the S VIDEO input jack:
Press V/v to select "On," then press
To watch the pictures input from the VIDEO input jack:
Press V/v to select "Off," then press
6
Press MENU to exit the menu screen.
75-ohm coaxial
cable (supplied)
Rear of TV
VIDEO IN
1 3
S VIDEO
VIDEO
L(MONO)
AUDIO
R
(red)
(Setup), then press
.
.
VHF/UHF
HD/DVD IN
4
Y
P
B CENTER SPEAKER
IN
180W (6 ) MAX
P
R
AUDIO OUT
L L(MONO)
(VAR/FIX)
AUDIO AUDIO
R
R
.
.
23