Viewing Pictures From Connected Equipment - Sony KDL-26T30xx Operating Instructions Manual

Viewing pictures from
connected equipment
Switch on the connected equipment, then
perform one of the following operation.
For equipment connected to the scart sockets using a
fully-wired 21-pin scart lead
Start playback on the connected equipment.
The picture from the connected equipment appears on
the screen.
For an auto-tuned VCR (page 7)
In analogue mode, press PROG +/-, or the number
buttons, to select the video channel.
For other connected equipment
Press / repeatedly until the desired input source
(see below) appears on the screen.
Symbol on the Description
screen
AV1 To see the equipment connected to I.
AV1/
AV2 To see the equipment connected to J.
AV2/
~
SmartLink is a direct link between the
TV and a VCR/DVD recorder.
To see the equipment connected to H.
AV3
AV4 HDMI IN 4*.
To see the equipment connected to E.
AV5 HDMI IN 5*.
To see the equipment connected to D.
If the equipment has a DVI socket,
connect the DVI socket to the HDMI IN
socket through a DVI-HDMI adaptor
interface (not supplied), and connect the
equipment's audio out sockets to the
audio in HDMI IN sockets.
~
*
• Be sure to use only an HDMI cable that bears the HDMI logo.
• When HDMI control compatible equipment is connected,
communication with the connected equipment is supported.
Refer to page 19 to set up this communication.
• When connecting an audio system with HDMI socket, be
sure to also connect to the HiFi socket.
18
GB
Symbol on the Description
screen
To see the equipment connected to B.
AV6 or
AV6
z
To avoid picture noise, do not connect
the camcorder to the video socket
and the S video socket
same time. If you connect mono
equipment, connect to the L socket
6.
To see the equipment connected to F.
PC
z
It is recommended to use a PC cable
with ferrites.
To connect Do this
Headphones A Connect to the i socket to listen to
sound from the TV on headphones.
Conditional To use Pay Per View services.
Access Module For details, refer to the instruction
(CAM) C
manual supplied with your CAM. To
use the CAM, remove the rubber cover
from the CAM slot. Switch off the TV
when inserting your CAM into the
CAM slot. When you do not use the
CAM, we recommend that you replace
the cover on the CAM slot.
~
CAM is not supported in all countries.
Please check with your authorized dealer.
Hi-Fi audio Connect to the audio output sockets
equipment G
to listen to the sound from the TV
on Hi-Fi audio equipment.
Additional operations
To Do this
Return to normal TV Press DIGITAL or ANALOG.
mode
Access the Input Press
signal index table signal index table. To select an
(except analog mode) input source, press
press
Change the volume of Press
the connected HDMI
control compatible
audio system
Mute the sound of the Press
Press again to restore.
connected HDMI
control compatible
audio system
6 at the
to access the Input
F f
/ , then
.
2
+/-.
%
.
6