Table of Contents
Advertisement
Getting Content
To install using the AutoPlay feature
The installation launcher appears when you connect
the Reader to your computer (AutoPlay feature is
available on Windows XP, Windows Vista only).
Make sure your computer is connected to an AC
outlet and turned on (not in sleep mode).
Connect the Reader to your computer using the
supplied USB cable.
The "Installer for Reader" window appears on your
computer.
* The screen displayed while connected via USB varies
depending on the usage environment.
Note
When the remaining battery power is extremely low, the
Reader may not be recognized. In this case, wait for about
5 minutes while the Reader is charging, then disconnect
and reconnect the USB cable. Within 3 minutes,
appear on the screen and the Reader will be recognized
by your computer.
Alternately, charge the Reader via an AC outlet for about 4
minutes. The screen will turn on and the Reader will be
recognized by your computer.
USB cable (supplied)
To an AC outlet
will
Continued
42
Advertisement
Table of Contents
