Sony RDR-GX700 Operating Instructions Manual page 24

10
Select the setting that matches your TV
type.
EASY SETUP
Select your TV screen type.
"16:9": For wide-screen TVs or standard TVs
with a wide screen mode.
"4:3 Letter Box": For standard TVs.
Displays "wide screen" pictures with bands
on the upper and lower sections of the screen.
"4:3 Pan Scan": For standard TVs.
Automatically displays "wide screen"
pictures on the entire screen and cuts off the
sections that do not fit.
For details, see "TV Type" on page 87.
11
Press ENTER.
The Setup Display for the component out
jacks appears.
12
Select an option.
Select "On" if you are using the
COMPONENT VIDEO OUT jacks.
Otherwise, select "Off."
13
Press ENTER.
The Setup Display for the LINE 3/DECODER
jack appears.
14
Select an option.
Select "Yes" if you will connect a decoder to
the LINE 3/DECODER jack. Otherwise,
select "No."
15
Press ENTER.
The Setup Display for selecting the type of
video signal output from the LINE 1-TV jack
appears.
EASY SETUP
Select the Line1 output signal.
24
TV Type
16 : 9
4 : 3 Letter Box
4 : 3 Pan Scan
Line1 Output
Video
S Video
RGB
16
Select the type of signal you want to output
from the LINE1-TV jack.
"Video": Outputs video signals.
"S Video": Outputs S video signals.
5/9
"RGB": Outputs RGB signals.
Note that if you select "On" in step 12, you
cannot select "RGB," and that if you select
"Yes" in step 14, you cannot select "S Video."
• If you select "S Video" or "RGB,"
SMARTLINK will be deactivated.
17
Press ENTER.
The Setup Display for selecting the type of
jack used to connect to your amplifier
(receiver) appears.
18
Select the type of jack (if any) you are
using to connect to an amplifier (receiver),
and press ENTER.
If you did not connect an AV amplifier
(receiver), select "No," then go to step 22.
If you connected an AV amplifier (receiver)
using just an audio cord, select "Yes: LINE 2
OUT (R-AUDIO-L)," then go to step 22.
If you connected an AV amplifier (receiver)
using either a digital optical or coaxial cord,
select "Yes: DIGITAL OUT."
19
Select the type of Dolby Digital signal you
wish to send to your amplifier (receiver).
8/9
If your AV amplifier (receiver) has a Dolby
Digital decoder, select "Dolby Digital."
Otherwise, select "D-PCM."
EASY SETUP
Audio Connection
Is this recorder connected to an amplifier (receiver)?
Select the type of jack you are using.
Yes : LINE2 OUT(R-AUDIO-L)
DIGITAL OUT
Yes :
No
EASY SETUP
Audio Connection
Dolby Digital
D-PCM
Dolby Digital
9/9
9/9