Sony RDR-GX700 Operating Instructions Manual page 101

Others
The recorder does not operate properly.
, Restart the recorder. Press down [/1 on the
recorder for more than ten seconds until
"WELCOME" appears in the front panel display.
, When static electricity, etc., causes the recorder
to operate abnormally, turn off the recorder and
wait until the clock appears in the front panel
display. Then, unplug the recorder and after
leaving it off for a while, plug it in again.
Five numbers or letters are displayed in the
front panel display.
, The self-diagnosis function was activated (see
the table on page 102).
The disc tray does not open after you press Z
(open/close).
, It may take a few seconds for the disc tray to
open after you have recorded or edited a disc.
This is because the recorder is adding disc data to
the disc.
The disc tray does not open and "TRAY
LOCKED" appears in the front panel display.
, Contact your Sony dealer or local authorized
Sony service facility.
"RECOVERY" appears in the front panel
display.
, The recorder's recovery function was activated
when the recorder was turned on because the
power was turned off or failed during recording.
Leave the recorder on until "RECOVERY"
disappears from the front panel display.
"FAN ERROR" appears in the front panel
display.
, Check that the vent on the rear of the recorder is
not blocked. Then, turn off the recorder, wait
until the clock appears in the front panel display,
and disconnect the mains lead. Leave the
recorder off for a while, then re-connect the
mains lead, and press [/1 on the recorder.
Mechanical sound is heard when the recorder
is off.
, While the recorder is adjusting the clock for the
Auto Clock Set function or scanning the
channels for the PDC/VPS function, operational
noises (such as the internal fan) may be heard,
even when the power is off. This is not a
malfunction.
The disc tray does not open and you cannot
remove the disc after you press Z (open/
close).
, Turn off the recorder. Once the clock appears in
the front panel display, disconnect the mains
lead. Connect it again while pressing down A on
the recorder, and release the button when the disc
tray opens. Then, keep [/
pressed for about ten seconds until
"WELCOME" appears in the front panel display.
"LOCKED" appears in the front panel display.
, The disc tray is locked. Cancel the Child Lock
(page 53).
1 on the recorder
101