Genie GCL OPGSX Series Installation Manual page 30

Calibration Mode Structure
If at any time should programming become confused. Press the CAL/RUN key once to enter RUN MODE then press CAL/RUN key again to
reenter CALIBRATION MODE.
Press the SCROLL key(s) to locate or check the settings on any menu item.
FDO Operator Calibration Menu Structure
1. SET CLOSE DIR> -HIT SET/CLEAR TO ENTER THIS MODE-
• PRESS CLOSE KEY BRIEFLY
• DID DOOR CLOSE?
• YES NO
2. UP LIMIT>SET OR CLR
3. DOWN LIMIT> SET OR CLR
4. MID-STOP> SET OR CLR
5. LIMIT OVERRUN> 0-9
6. OPEN MODE> C-STP OR MOM
7. CLOSE MODE> C-STP OR C-REV OR MOM
8. ODC STB> ON OR OFF
9. TLC DELAY> 0:00 TO 5:00
10. BRAKING RATE>0-9
11. MAX RUN TMR> SET OR CLR
12. GDO TYPE> TROLLEY OR J-SHAFT
13. FD DELAY TMR> 10/30
14. FD SAFETY TMR> 2M/4M
15. FD OBSTRCT CYL>1/2/3
16. FD STP ON OB>ON/OFF
17. FD AUTO OPEN>ON/OFF
18. FD PWR ALARM>ON/OFF
19. FD ALARM@DN L>ON/OFF
20. LEARN NEW XMTR? -HIT SET FOR YES-
• PUSH XMTR BUTTON TWO TIMES TO LEARN XMTR
21. REMOVE XMTR? - HIT SET FOR YES-
• ARE YOU SURE?-YES/NO
22. REMOVE ALL XMTRS? -HIT SET FOR YES-
• ARE YOU SURE?-YES/NO
23. CYCLES> 000000
24. GDO V#> 020.00.000
25. RUN CODE 1> CODE & DESCRIPTION
26. ERROR CODE 1> CODE & DESCRIPTION
NOTE: Menu structure will change when any auxiliary board(s) are added. See instructions for each auxiliary board for changes.
6.2
Section 6: Operator Setup Procedure
RUN MODE
CAL
RUN
CALIBRATION MODE
CAL
RUN
When returning to CALIBRATION MODE. Menu will
always start at the first item (SET MOTOR DIR) press the
SCROLL key to bypass this item until desired menu item is
displayed.
• Item 11 (MAX RUN TMR) will set itself once limits
have been programmed and door has run one
complete cycle.
• Items 26-27 (RUN and ERROR codes) will retain the
last 10 codes encountered. Press the SET/CLEAR
key to toggle through all codes.
OPEN
CLOSE
STOP
SET
SCROLL
CLEAR
SCROLL
OPEN
CLOSE
STOP
SET
SCROLL
CLEAR
SCROLL