Sony MZ-NH700 Operating Instructions Manual page 79

Message Meaning/Remedy
PROTECTED • You tried to record or edit on a disc with the tab in the record-protect
DISC position.
, Slide the tab back (page 65).
PUSH STOP • You tried to open the lid by sliding the OPEN switch while the recorder was
BUTTON storing disc information with the dedicated USB cable connecting the
recorder to a computer.
, Operation must be done only after pressing x and "SYSTEM FILE
READ • The recorder cannot read the disc information correctly.
, Reinsert the disc.
ERROR
REC ERROR • Recording was not correctly done.
, Place the recorder at a place with no vibrations and record again.
• The disc is soiled with an oil film or finger prints, is scratched, or is not a
standard disc.
, Try recording again with another disc.
SYSTEM • The recorder is storing information (track start and end position) from the
FILE memory to the disk.
, Wait until this process is completed. Do not expose the player to
WRITING
TEMP OVER • Heat has built up in the recorder.
, Let the recorder cool down.
REC STOP
TITLE FULL • You tried to enter more than 200 letters to label a single track, group, or
disc.
• You tried to enter a total of more than approximately 55,000 letters (in Hi-
MD mode) or 1,700 letters (in MD mode) for titles.
TOC DATA • The recorder cannot read the disc information correctly.
, Insert another disc.
ERROR
, If it is no problem to erase the entire disc, do so (page 52).
TRACK FULL • You tried to record more than 2,047 tracks on a disc in Hi-MD mode or
more than 254 tracks on a disc in MD mode.
, Erase unnecessary tracks (page 51).
TrkFromPC • You tried to combine or divide tracks that were transferred from the
NO EDIT computer.
, You cannot combine or divide transferred tracks.
• You tried to combine or divide tracks that were recorded in Hi-MD mode
using the MD Simple Burner software.
, You cannot combine or divide tracks recorded in Hi-MD mode with the
TrkFromPC • You tried to record in the middle of a protected track that has been
NO REC transferred from the computer.
• You tried to record in the middle of a track that was recorded in Hi-MD
mode with the MD Simple Burner software.
, You cannot record new material in the middle of a protected track or a
WRITING" has disappeared from the display.
physical shock, nor disrupt power supply.
MD Simple Burner software.
track that was recorded in Hi-MD mode with the MD Simple Burner
software.
79