Sony MZ-NH700 Operating Instructions Manual page 72

Symptom
There is no R-
channel sound output
when playing a track
recorded from a
cassette deck or
through an amplifier,
or when listening to
sound from a cassette
deck or amplifier.
While editing
Symptom
"NotENOUGH
POWER TO EDIT"
appears and editing
cannot be done on a
1GB Hi-MD disc.
The lid does not
open.
Editing cannot be
done.
Non-audio data
cannot be erased.
Tracks cannot be
combined.
72
Cause/Remedy
• There is no R-channel output if the cassette deck or an amplifier is
connected with a monaural cord.
, Make sure to use a stereo connecting cord. If, however, the
connected equipment is monaural, there will be no R-channel
sound output even with a stereo connecting cord.
Cause/Remedy
• Editing is not possible when using a 1GB Hi-MD disc even when the
battery level indication shows enough power remaining while the
recorder is stopped or playing. This is because of a mechanism that
disables editing when the remaining battery power is estimated by the
recorder to be insufficient due to the high power consumption required
for 1GB Hi-MD disc editing.
, Connect the AC power adaptor to the recorder or insert a fully
charged rechargeable battery or a new alkaline dry battery.
• The power sources have been disconnected during recording or
editing, or the battery have been exhausted.
, Set the power sources again, or replace the exhausted battery with
new ones.
• The power source has been disconnected or a power outage has
occurred during editing.
, The editing done to that point is not saved to the disc. Do the
editing operation again.
• Non-audio data cannot be erased with the Erase function.
, Confirm the contents by connecting the recorder to your
computer. If it is okay to delete the contents, then perform the
Format function (page 55).
• This is due to the MiniDisc system limitations. When the tracks are
scattered and the length of each track is short*, you may not be able to
combine the tracks.
* Combining tracks of the following lengths may not be possible.
Hi-MD mode
Linear PCM stereo: 9 seconds or less
Hi-SP stereo: 8 seconds or less
Hi-LP stereo: 32 seconds or less
MD mode
SP stereo: 12 seconds or less
LP2 stereo/Monaural: 24 seconds or less
LP4 stereo: 48 seconds or less