Sony MZ-NH700 Operating Instructions Manual page 73

Symptom
Tracks cannot be
combined.
The disc cannot edit
on other component.
While using group function
Symptom
The group function
does not operate.
A track cannot be
recorded to a new
group. A new group
cannot be created.
While the recorder is connected to the computer
Symptom
The recorder is not
recognized by the
computer.
Even though the
recorder is
recognized by the
computer, it does
not operate
normally.
The recorder cannot
be used as a storage
device.
Cause/Remedy
• You cannot combine tracks recorded in different recording modes,
e.g., a track recorded in stereo and a track recorded in monaural; nor
can you combine a track recorded with digital connection and a track
recorded with analog connection.
• The component does not support MDLP or Hi-MD.
, Edit on other component that support MDLP or Hi-MD.
Cause/Remedy
• While using a disc without group setting, an attempt was made to select
some group-related menu.
, Use a disc with group setting.
• This is due to the MiniDisc system limitations (in MD mode only).
Group information has been written to the area where the disc name is
stored. The disc name and track names are recorded in the same area,
which can store a maximum of approximately 1,700 characters. If the
total number exceeds this amount, a new group cannot be created even
though group mode is on. It is also impossible to make group settings at
this time.
Cause/Remedy
• The dedicated USB cable is not firmly connected.
, Connect the dedicated USB cable firmly to the recorder and the
computer.
• A USB hub is used.
, Connect the dedicated USB cable directly to the USB port of the
computer.
• Network communication has failed.
, Disconnect the dedicated USB cable, wait at least 2 seconds, and
then reconnect it. If the recorder is still not recognized, disconnect
the dedicated USB cable, restart the computer, and then connect the
dedicated USB cable again
• A USB hub is used.
, Connect the dedicated USB cable directly to the USB port of the
computer.
• You are using the recorder at a place with vibration.
, Use the recorder at a place with no vibration.
• The SonicStage or MD Simple Burner software is active.
, Close the SonicStage or MD Simple Burner software.
• A standard disc is inserted.
, Insert a disc used in Hi-MD mode. Only discs used in Hi-MD mode
can be used as a storage media.
73