Sony DVP-NS32 Operating Instructions Manual page 23

7
Press X/x to select the setting that
matches your TV type.
If you have a wide-screen TV or a 4:3
standard TV with a wide-screen mode
• 16:9 (page 66)
If you have a 4:3 standard TV
• 4:3 LETTER BOX or 4:3 PAN SCAN
(page 66)
8
Press ENTER.
The Setup Display for selecting the type
of video signal output from the LINE
(RGB)-TV jack appears.
SCREEN SETUP
TV TYPE:
SCREEN SAVER:
BACKGROUND:
LINE:
4:3 OUTPUT:
9
Press X/x to select the type of
signal you want to output from the
LINE (RGB)-TV jack.
Video signals
• VIDEO (page 66)
S video signals
• S VIDEO (page 66)
RGB signals
• RGB (page 66)
(DVP-NS52P only) When you select
"RGB," you will be unable to use the
PROGRESSIVE button, and the player
will not output video signals from the
COMPONENT VIDEO OUT jacks.
10
Press ENTER.
The Setup Display for selecting the type
of jack used to connect your amplifier
(receiver) appears.
Is this player connected to an amplifier
(receiver) ? Select the type of jack you
are using.
YES
LINE OUTPUT L/R (AUDIO)
DIGITAL OUTPUT
NO
16:9
ON
JACKET PICTURE
VIDEO
VIDEO
S VIDEO
RGB
11
Press X/x to select the type of
jack (if any) you are using to
connect to an amplifier (receiver),
then press ENTER.
If you did not connect an AV amplifier
(receiver), select "NO," then go to step
15.
If you connected an AV amplifier
(receiver) using just an audio cord, select
"YES: LINE OUTPUT L/R (AUDIO),"
then go to step 15.
If you connected an AV amplifier
(receiver) using either a optical or coaxial
digital cord, select "YES: DIGITAL
OUTPUT."
12
Press X/x to select the type of
Dolby Digital signal you wish to
send to your amplifier (receiver).
If your AV amplifier (receiver) has a
Dolby Digital decoder, select "DOLBY
DIGITAL." Otherwise, select "D-PCM."
AUDIO SETUP
AUDIO ATT:
AUDIO DRC:
DOWNMIX:
DIGITAL OUT:
DOLBY DIGITAL:
MPEG:
DTS:
48kHz/96kHz PCM:
13
Press ENTER.
"DTS" is selected.
AUDIO SETUP
AUDIO ATT:
AUDIO DRC:
DOWNMIX:
DIGITAL OUT:
DOLBY DIGITAL:
MPEG:
DTS:
48kHz/96kHz PCM:
14
Press X/x to select whether or
not you wish to send a DTS signal
to your amplifier (receiver).
If your AV amplifier (receiver) has a
DTS decoder, select "ON." Otherwise,
select "OFF."
OFF
STANDARD
DOLBY SURROUND
ON
D-PCM
D-PCM
DOLBY DIGITAL
48kHz/16bit
OFF
STANDARD
DOLBY SURROUND
ON
D-PCM
PCM
OFF
OFF
ON
,continued
23