Stanley Fat Max S2 Instruction Manual page 5

CERTIFICATIONS
This laser complies with all applicable portions of title 21
of the Code of Federal Regulations set by the Food and Drug
Administrations, Center for Devices, and Radiological Health.
Complies with 21CFR 1040.10 and 10040.11 except for devations
pursuant to Laser notice No. 50,
dated July 26, 2001.
This Laser tool has also been tested and complies with the CE
certification requirements set forth in the EC regulations
89/336/EEC and EN 61000-6-1 (EN50082-1), EN 61000-6-3
(EN50081-1) and EN 60825-1.
POWER
Open the battery cover by releasing the battery door clip on the
bottom of the housing. If replacing batteries, remove the
existing batteries. Insert three "AA" batteries into the laser tool.
Be sure to check for battery polarity, as indicated inside the
battery housing.
Note: Refer to Electrical Safety Procedures prior to replacing
the batteries.
Alkaline batteries offer the longest battery life when used in
this laser tool.
Note: Extreme temperatures and the use of batteries with
different levels of charge can reduce the operating time of the
laser tool. Always use batteries with the same power rating and
from the same manufacturer. For the proper disposal of the
used batteries, see the section "Environmental Protection".
ELECTRICAL SAFETY PROCEDURES
WARNING: Batteries can explode or leak, and can
cause injury or fire. To reduce this risk:
ALWAYS follow all instructions and warnings on the battery
label and package.
DO NOT short any battery terminals.
S2/S2XL • 5