Sony BDP-S1 Manual Addendum: Audio Codec Information (firmware ver 2.0 or higher) Operating Instructions Manual page 29

Symptom
"Low Battery" appears on the
display, and the CD does not play.
"Hi DC in" appears on the display.
The CD does not play, or "No Disc"
appears on the display when a CD
is placed in the player.
"HOLD" flashes on the display
when you press a button, and the
CD does not play.
Playback starts from the point you
stopped (resume function).
During playback of an ATRAC
CD or MP3 CD, the CD does not
rotate but you can hear the sound
normally.
"No File" appears on the display
after you press  /ENTER or
when the lid of the player is
closed.
Cause and/or corrective action
 The rechargeable battery is used up completely. Charge the
battery (  page 11).
 Replace the dry battery with a new LR6 (size AA) alkaline
battery (  page 10).
 An AC power adaptor which is rated higher than the one
supplied or recommended is being used. Use only the supplied
AC power adaptor or the car battery cord recommended in
"Optional Accessories" (  page 32).
 The CD is dirty or defective. Clean it or change it.
 Check that the CD is inserted with the label side up
(  page 14).
 Moisture condensation has occurred. Leave the CD player
aside for several hours until the moisture evaporates.
 Close the lid of the battery compartment firmly (  page 10).
 Make sure the battery is inserted correctly (  page 10).
 Connect the AC power adaptor to an AC outlet securely
(  page 13).
 Press 
/ENTER after one second or more has passed since
the AC power adaptor was connected.
 The CD-R/CD-RW in the player is blank.
 There is a problem with the quality of the CD-R/CD-RW,
recording device, or application software.
 The buttons are locked. Slide the HOLD switch back
(  page 16).
 The resume function is working. To start play from the first

track, press and hold
player is stopped until the first track starts playing, or open the
lid of the player (  page 15). Or, remove all power sources,
and then insert the battery or connect the AC power adaptor
again.
 This player is designed to stop the rotation of an ATRAC CD
or MP3 CD during playback to reduce the power consumption.
The player is not malfunctioning.
 There are no ATRAC3plus/MP3 files on the CD-R/CD-RW.
 A CD-R/CD-RW from which the data has been erased is being
used.
 The CD is dirty.
1)

/ENTER ( on the remote) while the
Continued 
29