Eco Dect - Gigaset Pro Maxwell C User Manual

ECO DECT

Deactivating the room monitor / cancelling the alarm
Deactivate room monitor:
Cancel the alarm:
Deactivating the room monitor remotely
The alarm is forwarded to an external destination number.
The receiving phone supports tone dialling.
If the alarm is activated via a VoIP connection, the DTMF signalling must take place
via SIP info or RFC2833 (
¤
Accept the alarm call
The room monitor is deactivated and the handset is in idle status. The room monitor settings
on the handset (e.g. no ringtone) will remain activated until you press the display key OFF.
The room monitor cannot be reactivated remotely.
Reactivate:
ECO DECT
(depending on the base)
The device range is set to maximum as default. This guarantees the best connection between
the handset and the base station. In idle status, the handset will not function (as it is not
transmitting). Only the base station will maintain contact with the handset via a low wireless
signal. During a call, the transmission power automatically adapts to the distance between the
base station and handset. The smaller the distance to the base, the lower the radiation.
To reduce the radiation further:
Reducing radiation by up to 80%
¤
. . . use
Range
The range is also reduced with this setting.
It is not possible to use a repeater to increase the range.
Deactivating radiation in idle status
¤
. . . use
Radiation
.internetvoipphone.co.uk | sales@internetvoipphone.co.uk | 0333 014 4
34
¤
In idle status press the display key OFF
¤
During an alarm press and hold the Back key
press the
p. 33
to select
Change ( = off )
to select
Change ( = on)
Availability and operation of the functions
may differ on your telephone.
setting on the base station).
keys
Settings OK
Settings OK
ECO DECT OK Maximum
ECO DECT OK No