Connecting Two Or More Cameras - Multi-Camera System - Sony DXC-9100P Operating Instructions Manual

Connecting Two or More Cameras — Multi-Camera System
Notes on multi-camera systems
Take the following steps to prevent flicker when switching
between two or more cameras connected to a video switcher.
• Supply the same sync signal to the EXT CTRL connectors
on each camera (see below).
Sync signal generator or
camera
Sync (VBS or BS) output
VIDEO IN
Video switcher, etc.
VBS (BS) OUT
Video monitor,
VCR, etc.
DXC-9100P
VIDEO OUT
75 coaxial cable
VBS (BS) OUT
VIDEO IN
VIDEO OUT
75 coaxial cable
CCDC-5/10/25/50A/100A cable or CCMC-12P02/05/20/25 cable
Set "EXT.CTRL (BNC)" to "GENLOCK" on PAGE 3 menu.
For details, see page 23.
• Adjust the subcarrier and horizontal synchronization
phases for all cameras.
For more details, see "Adjusting the Picture Tone in a Multi-
Camera System" on page 37.
FREEZE
MENU FUNCTION DATA
LENS
UP
WHITE
SOURCE BARS
DOWN DC IN/VBS
CCU
SCAN
RGB/SYNC
REMOTE
VIDEO OUT
DC IN/
EXT CTRL
VBS
EXT CTRL
CCDC-5/10/25/50A/100A cable or
DXC-9100P
CCMC-12P02/05/20/25 cable
FREEZE MENU FUNCTION DATA
UP LENS
WHITE
SOURCE BARS
DOWN DC IN/VBS
CCU
RGB/SYNC SCAN
VIDEO OUT REMOTE
DC IN/
EXT CTRL
VBS
EXT CTRL
CMA-D2CE/D2MDCE camera adaptor
1 Set the MODE selector
to the "1" position.
2
CAMERA (4-pin
or 12-pin)
Power cord
CMA-D2CE/D2MDCE camera adaptor
1 Set the MODE selector
to the "1" position.
2
CAMERA (4-pin
or 12-pin)
Power cord
AC IN
AC IN
45