Table of Contents
Advertisement
3. After the cover is fitted, turn the tap fully clockwise to
the end stop and stopped at upright position.
Step 6 – Installing Filter
To install a filter, insert the filter into the base of the unit as shown and turn 90° until a click or stop point is reached, see
images below. There should be approximately 20mm of the filter protuding when installed.
NOTE: For safe operation, the filter cartridge should be replaced every 6-12 months, or earlier if you notice a
persistent reduction in water pressure from the appliance or an unpleasant taste or odour in the water. Refer to
Filter Replacement section on page 21 for instructions of changing filter.
Step 7 – Commissioning - Filter Flush & Calibrate
FILTERED
FILTER FLUSH
Rotate filter switch
to FILTER FLUSH
Fig.1
804545NZ - BW_AB Small_09.18 v1.02
Installation Procedures
1. Insert the filter
4. Use the spanner supplied to tighten the lock nut
anti-clockwise.
20mm
2. Turn the filter through 90° until
fully engaged
Warning: Do not turn on the power until instructed.
Water must first be available from the tap outlet to
prevent damage.
1. The filter flush valve switch is located on the left side of the
unit. Check that it is in the correct position to perform a filter
flush. Rotate the filter flush switch (either way) to point down
to the "FILTER FLUSH" position, as shown in Fig.1.
2. Turn on the mains water. Allow at least 5 litres of water to
flush through the filter. Make sure there is water flowing from
Lock nut
Page 7 of 24
Advertisement
Table of Contents
